Mighty Buildings ADU Design & Permitting: The Whitney Owner’s Guide
Design and permitting for a Mighty Buildings ADU in Whitney usually runs $9,000 to $18,000 for the full package: site survey, stamped drawings, Mighty Buildings’ factory panel coordination, and Clark County permitting through to the approved permit and inspection sign-off. The engineering drawings and site plan come from Mighty Buildings; the permit strategy, submittal and inspections are handled locally. Most owners discover they need this help when a permit submittal comes back with a correction notice, or when they’re told the lot can’t take the unit size they picked. If that sounds familiar, you’re not alone, and we handle it every week in Whitney.
Which Mighty Buildings Models This Applies To

Mighty Buildings has shipped several lines over the years, and the design and permitting package depends on which one you have. The single-story studio and one-bedroom units share a panel system, so the structural drawings are close, but the foundation plan is not: the 3D-printed and panelized units set differently on a Nevada pad than they do on the coastal sites the original generic drawings were built around. Whitney’s soils, wind exposure and frost depth are the local gotchas, and a set of drawings that hasn’t been adapted for Clark County will get corrected.
Identify your model from the nameplate inside the utility panel and the unit’s serial tag, then check the model code on your original Mighty Buildings paperwork. That code is what tells us which drawing package applies and whether a stock package can be adapted or the unit needs a fresh site-specific set. Expect the design and permitting package to run $1,200 to $3,200 per revision cycle if your drawings need re-engineering for local conditions. Independent service providers work alongside Mighty Buildings’ own documentation; Sutton ADU Builders Whitney is not affiliated with Mighty Buildings.
Signs Your Mighty Buildings ADU Design & Permitting Is Failing
- You’ve received a correction notice from Clark County. This means the submittal missed a code item, usually egress, energy or site drainage. The fix is a revised drawing set, not a new application.
- Your zoning setback doesn’t match the drawing. The plan shows the unit closer to the property line than Whitney’s lot standards allow. A setback is the required gap between your structure and the property line; it’s checked against an actual survey, not your memory.
- The unit size exceeds your lot coverage. The design was drawn before anyone checked your lot’s allowable footprint. Coverage limits vary by lot, and this is the single most common reason a submitted plan has to be redrawn.
- Your HOA wants documents the package doesn’t have. The design package was submitted without the HOA’s architectural-review forms. Missing those stalls a permit even when the county has no issue with the plan.
- Good drawings, no permit in hand. The design is finished but nobody pulled the permit, so no inspection can happen. The unit can’t be legally occupied, which is the real failure.
Replacement Cost & What’s Included
In Whitney, the design and permitting package typically lands between $9,000 and $18,000 installed. What drives the range: whether your lot needs a survey, how much the drawings need adapting for Clark County, whether HOA review is involved, and whether the unit is a single-story studio or a two-bedroom. The design line, the permit and inspection fees, and the site-plan prep are quoted separately in a written line-item quote, so there’s no surprise invoice when the county adds a fee or a revision is required. Labor to manage the submittal and inspections is included. The 365-Day Done Right Promise covers defects in workmanship for one full calendar year from project completion. It doesn’t cover county fees or new code changes after the fact, and we’ll say so plainly when we quote.
DIY or Call Us?
Here’s the honest split. You can absolutely check your own lot: pull your lot survey, confirm your property-line setbacks, and read your HOA’s architectural rules before anyone draws a plan. That’s free and it saves time. Where DIY goes wrong is the submittal itself. Clark County will not accept a homeowner-drawn plan for a new habitable structure, and a rejected submittal restarts the clock and your fee. The design and permit work for a Mighty Buildings unit needs an engineer’s stamp and an understanding of the local code, and doing it wrong is where people get stuck for months. Call (844) 797-4814 to schedule a free estimate and we’ll tell you exactly which parts you can handle yourself.
FAQs

Expect 10 to 16 weeks from a complete site survey to an approved permit. The timeline is driven by how fast the survey and Mighty Buildings’ drawing release come together, how deep the county’s review queue is, and whether a revision is triggered. Call (844) 797-4814 for a free estimate on the full package.
Usually the drawings need adapting for Whitney, not replacing. The structural system is set by Mighty Buildings, but the site plan, foundation, drainage and local code sheets have to be reworked for Clark County’s conditions. We’ll tell you which parts apply and which need adapting before you pay for anything.
Yes. The quote covers the permit application, submittal and coordinating inspections through final sign-off. We don’t hand you a permit number and walk away.
We coordinate with Mighty Buildings’ documentation and our own engineer to adapt the set for Clark County, then manage the submittal and inspections start to finish. You get a written price before any work begins, and the crew that shows up in Whitney is background-checked and photo-badged with their name sent to you in advance. Call (844) 797-4814 for your free estimate.
Written by the team at Sutton ADU Builders Whitney, serving Whitney and nearby areas.











